by Dremel ®
Tools & Accessories
11/4" thick x 5" wide x 2 feet poplar, aspen or choice of wood
13/4" thick x 3" wide pine board about 12" long
1Paint & Paintbrush (if desired)
Let's Get Started
To reduce the risk of injury user must read instruction manuals for all tools used in this project. Wear eye and respiratory protection. Use clamps to support work piece whenever practical.
You can follow our steps to create any word art you'd like. In keeping with our Halloween theme, we chose the word BOO! You can use our template or create your own on your computer by selecting a font, typing your word with letters about 5" in height and print out. We spray mounted our print out on the 1/4" material.
Cut out each letter from your 1/4" material for easy maneuvering in the Moto-Saw when making your detailed cuts.
Cut the letters out from the blocks with the stencils mounted on them using the Dremel Moto-Saw. Mount your Moto-Saw base station to any table you'd like to work on and snap the tool into place. Place your MS51 Wood and Plastic Cutting blade into your tool. Install your accessory, set your tool to a speed of (6) and cut out your design. TIP: For interior cuts in your design, drill a small hole in the area you need to cut, mount your MS51 blade through the hole and complete your cut.
Lay out your letters on top of your 3/4" material which will serve as the base for this decoration. Once you've determined how you would like to space your letters, cut your 3/4" to size using your Saw-Max and SM500 wheel, leaving an extra 2" of space at each end.
To secure the letters into place, you'll need to cut two thin supporting strips of 1/4" material to form a channel on your base. Measure and mark two strips at about 3/8" width and as long as the base you cut in the last step. Make these rip cuts using your Saw-Max tool with the same SM500 blade as you used in step 4.
Find the center of the 3/4" thick base and draw a line along the length. Glue and fasten one of the 3/8" x 1/4" strips to the base about 1/8" away from the center line. Using the fastened strip, hold one of the letters against it and glue and fasten the second strip to the front edge of the letter tight. Move the letter to the other end and repeat creating a tight groove for the letters to rest in.
Sand and paint letters and base for desired design and once dry set your letters into place!
Other Projects You Might Like
home decorWooden Wall Cubbies
home repairTop Things to Avoid When Grinding and Sharpening
home decorWall Clock
seasonalCustomize Your Own DIY Wine Gift Box this Christmas