Project Details - dremel.com

like (0) I made it (0) Email Print

STEPS

4

SKILL LEVEL beginner

Use your space to its full potential with an idea board! We made our idea board fully equipped to hold any type of inspiration or note we didn’t want to forget!

by Dremel ®

231 PROJECTS

Grid View List View

Supplies Needed For This Project

TOOL

SM20 Saw-Max Tool Kit

Model # SM20

ACCESSORY

SM500 Wood & Plastic Carbide Wheel

Model # SM500

ACCESSORY

SM510 3" Metal Cut-Off Wheel

Model # SM510

Tools & Accessories

Materials

1
Chalkboard Paint
1
Sheet Metal
1
Chalk
1
Magnets
1
Drill Driver
1
Gloves

Let's Get Started

To reduce the risk of injury user must read instruction manuals for all tools used in this project. Wear eye and respiratory protection. Use clamps to support work piece whenever practical.

STEP 1

Step 1

Measure the space you want your idea board to fill. Cut a piece of MDF or plywood to that size. Here we used MDF to achieve a nice, smooth finish. Draw your cut lines on your MDF and clamp it onto your work table. Using a Dremel Saw-Max and SM500 Wood and Plastic Wheel, cut along this line. You will see how easy it is to achieve a smooth, straight cut - following the cut line through the notch at the head of the tool. Paint the newly cut piece with chalkboard paint and allow to dry (Cure time can take up to 24 hours. Refer to instructions from paint manufacturer). While your chalkboard paint is drying you can cut your other material for the board. (See next step)

STEP 2

Step 2

You can fill this idea board with various types of material including peg board, dry erase boards, cork board and more. Here, we wanted the ability to hang items with magnets so we chose to add sheet metal to our idea board. We decided to give the board a checkered look by dividing the board into 4 sections, alternating metal and chalkboard surfaces. To do this, take the total measurement of your cut from step 1. Ours measured 36" wide by 36" tall. Divide this into 4 square tiles - 4 sections of 18" by 18" squares. Measure and mark your cuts for 2 of these 18" by 18" square tiles in sheet metal and clamp it into place on your work table. With a quick accessory change from step 1, place a Metal Cutting wheel into your Saw-Max. Following the marked line as you did with step 1, move your tool slowly through the metal. Remember to let the speed of the tool do the work.