STEPS
SKILL LEVEL
by Dremel ®
226 PROJECTS
Tools & Accessories
Materials
-
1
Dremel 150 1/8" Drill Bit -
1
Sheet of 24" x 48" - 3/4" Thick Sanded Plywood -
1
12" of 3/4" Wooden Dowel -
1
Wood Glue -
1
Hammer and 8d Finishing Nails -
1
Drill & 2 Wood Screws -
1
Paint & Paintbrushes
Let's Get Started
To reduce the risk of injury user must read instruction manuals for all tools used in this project. Wear eye and respiratory protection. Use clamps to support work piece whenever practical.
Step 1
Begin by cutting out the bottom and sizes of the kit. You can complete all cuts using the Dremel Saw-Max and the SM500 Wood & Plastic Wheel. Measure, mark and cut the following 5 pieces: • Bottom: 12" by 4" • 2 Long Sides: 10 1/2" by 4 1/2" • 2 Short Sides: 8" by 6" Tip: In the interest of safety and accuracy, be sure to clamp your material.
Step 2
Next, cut the top corners of your two short side pieces at an angle. To draw the lines of your angle: Make a small mark an inch and 1/4 in from either side on the top Make a small mark 4 1/2" from the bottom. Then, connect each of the top marks to the bottom mark. You can make these angle cuts with the same SM500 Wood & Plastic Wheel. With your material clamped, simply follow your marked lines of cut through the notch at the front of your Saw-Max tool.
Suggested Videos
Maker Gallery
Be the first to upload a photo of your completed version of this project!
Upload A Photo
Other Projects You Might Like
craft and hobby
Cosplay for Beginners: Wayne’s Workshop Teaches You How to Make Cosplay Costumes and Props0
2months ago
SHOW US WHAT YOU MADE
Send us a photo of your Dremel creation so we can share it with the world.
TOUR THE MAKER GALLERY
Explore the creations added to the Maker Gallery by Dremel Makers.
Dremel Experts
From drilling holes to distressing denim, Dremel’s Customer Service has an answer.
Comments(0)
Sign In to post comments on this project.
No comments yet.