STEPS
SKILL LEVEL
by Dremel ®
227 PROJECTS
Tools & Accessories
Materials
-
1
4' x 4' x 3/4" Plywood -
1
10' of 4" PVC Pipe -
2
(2) 4" 90 Degree PVC Elbow Connectors -
5
(5) 6" x 1/2" Carriage Bolts -
5
(5) 1/2" Washers -
5
(5) 1/2" Nuts -
2
(2) 2' x 1/2" Rope Strands -
1
Horseshoe Set with Stakes -
1
Tape Measurer -
1
Pencil -
1
Drill -
1
Wrench -
1
1" Hole Saw or Spade Bit -
1
1/2" Drill Bit -
1
Sand
Let's Get Started
To reduce the risk of injury user must read instruction manuals for all tools used in this project. Wear eye and respiratory protection. Use clamps to support work piece whenever practical.
Step 1
Mount the US500 Carbide Wood Cutting Wheel onto your Dremel Ultra-Saw tool. Measure and mark the 3/4" plywood to 4' x 4'. Clamp the wood and cut along your marks. Note that our instructions are for one horseshoe pit. If you'd like to create more than one, adjust the supplies as needed and complete each of these steps for the additional pits.
Step 2
Measure and mark the 4" PVC so that there are two 42" lengths and a 30" length. Using the Ultra-Saw and US500 wheel cut through the PVC along these marks to create three separate tubes of PVC. Fit your cut pieces into the two 90 degree PVC elbow fittings to form the "U" structure of the horseshoe pit frame. When fitting the tubes into the elbows make the 30" piece of PVC the centerpiece and have the two 42" pieces serve as the sides.
Suggested Videos
Maker Gallery
Be the first to upload a photo of your completed version of this project!
Upload A Photo
Other Projects You Might Like
TOUR THE MAKER GALLERY
Explore the creations added to the Maker Gallery by Dremel Makers.
SHOW US WHAT YOU MADE
Send us a photo of your Dremel creation so we can share it with the world.
Dremel Experts
From drilling holes to distressing denim, Dremel’s Customer Service has an answer.
Comments(0)
Sign In to post comments on this project.
No comments yet.